Wheel Hub Cap 0009182003 – Linde 351-392 H Series

Wheel Hub Cap 0009182003 — Linde 351-352-391-392 H Series & IC Forklift Models

The Linde wheel hub cap 0009182003 is a direct-fit replacement dust cover engineered for the front wheel hub assemblies on Linde 351, 352, 391, and 392 H-Series electric and IC engine counterbalance forklifts. This stamped steel hub cap bolts to the outer face of the wheel hub, creating a contamination barrier that prevents warehouse dust, moisture, and debris from entering the wheel bearing cavity — a critical function in Linde forklifts operating in paper mills, cold storage, food processing, and heavy manufacturing where bearing contamination is the leading cause of premature hub failure. The 0009182003 is manufactured to Linde OEM bolt pattern and flange profile specifications, ensuring a flush seal against the hub face without the gaps or warping common in universal aftermarket caps. If your Linde forklift shows grease weeping around the hub cap edge, a bent or dented cap flange, or audible bearing noise during wheel rotation, the hub cap seal has likely been compromised and the bearing should be inspected while replacing the cover.

Replacing the 0009182003 hub cap requires removing the wheel to access the hub face — on Linde 351-392 series forklifts, the cap is typically retained by perimeter bolts accessible after the wheel is removed. Before installing the new cap, thoroughly clean the hub mating surface with a wire brush and solvent to remove all traces of old gasket material, rust scale, and hardened grease — any contamination trapped between the cap and hub face creates a leak channel. Linde OEM specifications call for a gasket between the cap and hub; if your replacement cap does not include one, cut a new gasket from 0.8mm gasket paper or apply a continuous 3mm bead of RTV silicone gasket maker around the cap flange. Torque the retaining bolts in a cross pattern to Linde service manual specification — typically 8-12 Nm for M6 bolts. After installation, spin the hub by hand and verify the cap does not contact any rotating components. The most common failure point on these hub caps is impact damage from fork tine strikes or dropped pallets that bends the cap flange and creates a permanent leak path.

This hub cap is a direct replacement for Linde models 351, 352, 391, and 392 H-Series electric and IC engine forklifts specifying part number 0009182003. Confirm your model before ordering. Browse our Wheel Hub Cap category for additional Linde hub caps, gaskets, and bearing kits. For OEM specifications, visit Linde Material Handling official site.

Technical Specifications

Compatible Forklift Models

Each hub cap is inspected for flange flatness and bolt hole alignment before shipment. Standard export packaging. For bulk orders or other Linde forklift spare parts, contact us with your part numbers.